Philips AVENT SCD510 User Manual download pdf (Page 14)

ENGLISH14

Question Answer

Why does the parent unit

react too quickly to other

sounds?

The baby unit also picks up other sounds than those of your

baby. Move the baby unit closer to the baby (but observe the

minimum distance of 1 metre/3 feet).

The microphone sensitivity level of the baby unit may be set too

high. Decrease the microphone sensitivity level with the

SENSITIVITY button on the parent unit.

Why does the parent unit

react slowly to the baby’s

crying?

The microphone sensitivity level of the baby unit may be set too

low. Increase the microphone sensitivity level with the SENSITIVITY

button on the parent unit.

Why do the non-

rechargeable batteries of

the baby unit run low

quickly?

The microphone sensitivity level of the baby unit may be set too

high, which causes the baby unit to transmit more often. Decrease

the microphone sensitivity level with the SENSITIVITY button on

the parent unit.

The volume on the baby unit may be set too high, which causes the

baby unit to consume a lot of energy. Decrease the volume of the

baby unit.

Perhaps you have switched on the nightlight. If you want to use the

nightlight, we advise you to run the baby unit on mains power.

Why does the charging

time of the parent unit

exceed 8 hours?

The parent unit may be switched on during charging. Switch off the

parent unit during charging.

The specied operating

range of the baby monitor

is 330 metres/1000 feet.

Why does my baby

monitor manage a much

smaller distance than that?

The specied range is only valid outdoors in open air. Inside your

house, the operating range is limited by the number and type of

walls and/or ceilings in between. Inside the house, the operating

range is up to 50 metres/150 feet.

Why is the connection lost

every now and then? Why

are there sound

interruptions?

The baby unit and the parent unit are probably close to the outer

limits of the operating range. Try a different location or decrease the

distance between the units. Please note that it takes about 30

seconds each time before a connection between the units is

established.

What happens during a

power failure?

If the parent unit is sufciently charged, it continues to operate

during a power failure, both connected to and disconnected from

the adapter. If there are batteries in the baby unit, it also continues

to operate during a power failure.

Is my baby monitor secure

from eavesdropping and

interference?

The DECT technology of this baby monitor guarantees no

interference from other equipment and no eavesdropping.

The operating time of the

parent unit is supposed to

be at least 24 hours. Why

is the operating time of my

parent unit shorter?

When the parent unit has been charged for the rst time, the

operating time is less than 24 hours. The rechargeable batteries only

reach their full capacity after you have charged and discharged

them at least four times.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 135 136

Comments to this Manuals

No comments

Philips AVENT SCD510 User Manual Page 14

Comments to this Manuals

Related products and manuals for Babyphones Philips AVENT SCD510